Automagic Forum

I missed the boat reporting this minor bug for 1.13.0 and now that 1.14.0 is out, I verified that this bug still exists.

Reproducing bug:
- create new trigger: Power Source
- select radio button: Disconnected
- save this trigger
- when editing this trigger again the radio button says "Connected"
- when physically disconnecting the power source the trigger does activate properly

This simply caused me some confusion for a bit, but the trigger does work. Thank you.

Thanks for your report, this should be fixed in the next update.

Has the version correcting this been released? If so, it is still not fixed, as I just imported a flow from the flow sharing forum that used it to lock the screen on or off depending on whether the power was connected .

Thanks!

Not yet. I will be fixed in the next update (1.15).