Power Source setting "appears" incorrect

[cunningt]

I missed the boat reporting this minor bug for 1.13.0 and now that 1.14.0 is out, I verified that this bug still exists.

Reproducing bug:
- create new trigger: Power Source
- select radio button: Disconnected
- save this trigger
- when editing this trigger again the radio button says "Connected"
- when physically disconnecting the power source the trigger does activate properly

This simply caused me some confusion for a bit, but the trigger does work. Thank you.

[Martin]

Thanks for your report, this should be fixed in the next update.

[saherr1969]

Has the version correcting this been released? If so, it is still not fixed, as I just imported a flow from the flow sharing forum that used it to lock the screen on or off depending on whether the power was connected .

Thanks!

[Martin]

Not yet. I will be fixed in the next update (1.15).