The problem was:
When I am in my office I want calls to be forwarded to office number, when at home to homenumber.
But often I am neither at home nor in the office and then want call forwarding only in case of not beeing reachable either to mailbox or to a callcenter depending on time.
This works fine with me now, but as I adjusted numbers and translation into english, I cannot test it anymore.
Hope you find it useful.
http://automagic4android.com/flow.php?i ... 39398ea1cf
Call Forwarding based on time and place
Moderator: Martin
Re: Call Forwarding based on time and place
I forgot to send the trigger flows of reaching and leaving home and office ... Here is the complete set...
http://automagic4android.com/flow.php?i ... a9816d7c75
http://automagic4android.com/flow.php?i ... a9816d7c75
Re: Call Forwarding based on time and place
I have successfully used the mmi code too.
Initially used wifi as a trigger but I have no phone signal at home so can not send the codes once I am home. Using the wifi trigger was therefore too late.
I have used the location trigger to divert when I am approaching home. If connected to bluetooth handsfree, it diverts when within 250m. If not connected to bluetooth handsfree the geofence is smaller as I am probably walking.
I would like to be able to check the status of divert too. This would prevent false triggers and divert requests . If I am at home, the location can wander. This can cause false trigger if it strays outside the geofence and then comes back in again. If I have no signal this can cause phone to freeze as the step can not complete.
There is a divert icon in the notification bar. I would like to be able to check if this is present as a contact condition. If I could do that, the solution would be just about spot on.
Initially used wifi as a trigger but I have no phone signal at home so can not send the codes once I am home. Using the wifi trigger was therefore too late.
I have used the location trigger to divert when I am approaching home. If connected to bluetooth handsfree, it diverts when within 250m. If not connected to bluetooth handsfree the geofence is smaller as I am probably walking.
I would like to be able to check the status of divert too. This would prevent false triggers and divert requests . If I am at home, the location can wander. This can cause false trigger if it strays outside the geofence and then comes back in again. If I have no signal this can cause phone to freeze as the step can not complete.
There is a divert icon in the notification bar. I would like to be able to check if this is present as a contact condition. If I could do that, the solution would be just about spot on.